EMEC FACO basic dosing pump set, 60 L (EN)

• Simple and reliable design (solenoid pump)
• Built-in electrical protection against power surges and overvoltage
• Good chemical resistance against broad range of chemicals
• High accuracy with low flow rates
• Continuous chemical injection
• Suitable for high flowapplications
• High wear resistance indemanding conditions
• High precision in a broad flowcontrol range (logarithmiccontrol scale)

Operation

Operation of the dosing station presents accurate supply of small volumes of reagents from the tank into the water flow line with a dosing pump. The dosing pump sucks the solution out of the reagent tank, and delivers its certain volume to the system.

A filter is installed at the suction valve of the dosing pump to prevent sediments from entering the pump resulting in its clogging.

Technical parameters

• Dosing mode - constant
• Nominal back pressure (P_nom) - 1.5 bar
• Flow rate at P_nom - 7.5 L/h
• Maximum back pressure (P_max) - 3 bar
• Flow rate at Pmax - 6.5 L/h
• Volume of one injection - 0.72 mL
• Injection frequency - 0..150 injections/min
• Suction height (max) - 1.5 m
• Noise level - 74 dBA
• Dosing pump power - 16 W
• Power supply - 230 V, 50 Hz
• Temperature limit within the premises - 0...45 °С
• Temperature limit during storage / transportation - °С -10…+50 °С
• Temperature of dosing solutions - 0..50 °С
• Material of components which contact with the dosing substance - FPM (Viton® B) or EPDM
• Reagents tank volume -60 L
• Reagents tank dimensions (diameter x height) - 370x640 mm

Components

• EMEC FACO dosing pump
• Foot filter with suction valve
• Injection valve
• Set of tubes for connection
• Reagent solution tank